Fuel change table not working

[colodano]

Just updated my Smanager software from 2.5.0 to the beta 2.5.2, and now I am not getting any estimated fuel change readings. I drove around datalogging for awhile this morning and never got anything, when it was working fine before the software update. I even made sure to enable the realtime updating in Options.

S300 V2 on a P06, PLX wideband and everything else is working as it should...

Any ideas, or is there a way to go back to the 2.5.0, I know it is not recommended, but seems like it is my best fix for now?

Thanks Dan

[Spunkster]

Post your calibration and a datalog showing the issue.

[colodano]

Here is my current Calibration, I will have to take another datalog to send, but maybe the cal will give a clue?

[Spunkster]

I need the datalog showing the issue.

[colodano]

Sorry for the delay, here is a datalog to hopefully help. As of this morning, still nothing populating that table. Also attached a picture of the blank table.

Just to make sure that all the pertinent info is there...
1993 Prelude
H22A stock longblock
ID1000 injectors
ported intake manifold with 76mm Throttle body, no IACV, FITV.
Highend header, Thermal catback.
S300V2 on a P06 ecu with VTEC.
PLX wideband sm-afr, and gauge.

[Spunkster]

It is working correctly here with the calibration and datalog you have provided. Try rebooting your laptop.

[colodano]

Thanks, I will give that a shot.

Going to be out of town for a bit, so I will post up if I still have issues next week.