AEM 4100 Install Question

[Ichigo1187]

Hello I'm new to Hondata, I just recently installed and AEM 4100 Wideband into my car, I'm using it as a secondary O2 sensor just for my A/F ratio, it was my understanding that I could wire the white output wire to my ECU (PR4 with Hondata S300 V1) so I can read A/F ratios in SManager, but for the life of me I can not figure out where to wire it to and how to set it up in SManager, PLEASE HELP! Thanks ahead of time for any advice given!

[Spunkster]

https://www.hondata.com/techplxwiring.html

The wire colors will be different, but the idea is the same.

[Ichigo1187]

Thank you Spunkster, do you have any idea why intermittently on light throttle my TPS does not read and it will go into fuel cut? I have checked all my wiring and calibrated my TPS 3 times now and for some reason it will act up here and there.

[Spunkster]

It sounds like either a wiring issue or a bad TPS sensor.

[Ichigo1187]

Thanks, I will double check everything.