Help Install PLX wideband

[Spunkster]

You may find this helpful: https://www.hondata.com/techplxwiring.html

[Spunkster]

You will need to look at the documentation that came with the wideband and then use the instructions we provided to wire it to the ECU.

[Xtremebb20]

not sure where to post this ? so its going here. I just installed the PLX wide band module gen 4 in my crx and removed the R136 and R138 resisters now I'm getting code 43 on smanager and P0169 on the hondata app. code is for Fuel Compensation and was wondering how I can fix this. I seen that my S. Fuel trim dips to -30 and that activates the cell after that is stays around 2 the a/f is at 13.22 any thoughts? Engine is spuddering while under steady throttle. I also looked at the datalog and my Short Fuel trim is all over the place. I attached a datalog to see if this helps.

[Spunkster]

It probably needs to be properly tuned.

[Xtremebb20]

yeah I figured that lol. I just got all of it put together and now it don't run right. oh well Humble is 2 hours away.

[Xtremebb20]

hey spunkster did you get a chance to check out the datalog?

[Spunkster]

It's really hard to tell anything from just a datalog and no calibration, but it sounds and looks like it is probably just a tuning issue and once properly tuned should run properly.