Ethanol Sensor Input Issues

[Bdavis]

Hi,
I am running the following
S300 V3
GM Ethanol Sensor - Fed with 12V, GND, and Vout heading to Analog Input 0.

I have verified connections and voltage. I have basically done everything I can without a scope.

I have chosen that input in the Flex Fuel Parameters, but I am not reading any input from the sensor when I data log.

Any ideas on what I could be doing wrong?

Thanks

[Bdavis]

Also running 2.5.0.0
installed 2.4 kOhm resistor across Vcc (12V) and Vout.

[Hondata]

Double check the connections to the sensor and the resistor. Otherwise it sounds like it is correct.
What have you selected in the calibration? Are you running the latest software?

[Bdavis]

So after letting it sit for a day, everything works. All I did in between was reboot the laptop and ecu one more time. Go figure... I'm happy :)


I am running 2.5.0.0


Thanks

[Hondata]

Glad that it is working ok for you.