Adjusting tps and now car wont run

[boostedb18]

So i was adjusting the tps on my s300 v3 and the car starts right up but dies immediately, the car was driving just fine until i uploaded the new settings.
What could have happened? This is my daily and i need to figure this out immediately

[Spunkster]

Close the program, reopen it, then load your calibration and upload it to the ECU again and that should correct it. You probably just had a partial upload.

[boostedb18]

Restarted the laptop and reuploaded the tune. Tps values are set to 0.63-97.23. The car starts right up but stall right away. Nothing other than the tps values were changed

[Spunkster]

What is the serial number on the s300? From Help, About, what is the version of software you are using?
Post your calibration and a datalog showing the problem.

[boostedb18]

I will post everything in the morning I'm not with the car now, thank you

[Coupe1995]

Any news on this? I'm having the same issue. As soon as I crank the car it dies immediately

[Hondata]

Follow the posting guidelines and post your details.