aem wideband

[vtecinside999]

thx a lot, i try everything out ;)

[murdoch]

its the 30-4100 and im using analog 0 red wire. this was working fine until I done the update

[vtecinside999]

Hi. You got the same Problem???
With which version does it work before?

[murdoch]

Yeah same problem on the display the a/f reads 10.0-1. My dataloging still works just not showing afr's. I cant remember what the previous version i was on when it worked but since this update my car wont idle either

[vtecinside999]

Today i try a lot things.... nothing changed. The harness at the gauge backside cant be upside down so its ok. I try the settings use analog in as wideband. Still shows 10.0 :( :(

[vtecinside999]

But why its showing then 10.0 only on the right analog in?

[olivenoire]

to follow...

Same for me.

What I ave to say is I can't understand why kpro/kmanager (at least rev3)
1) it is so hard to set up AEM wideband analogic or digital and
2) why it is so hard to find how to set low boost high boost in boost by gear using a switch

For the 1) i will read again this topic
For the 2) I will need to open a new one

regards

[vtecinside999]

Gauge shows everything right.
Example:
I accelerate the gauge shows 13.2:1 and the log shows 10.0:1. I can do what i want... it shows always 10.0:1
If i do the settings: use analog x as wideband. Then the A/F in Datalog shows 10.0:1,too. All time

[vtecinside999]

heres a new datalog and calibration.

[vtecinside999]

The Connector inside the ECU was off!!! Very goood!! I hope its working now. To bad wheater to test it... i dont want to drive in shity wheater ;)

[vtecinside999]

its working now. THX to everyone

[vtecinside999]

the A/F log is dancing Lambada. is it normal?

[vtecinside999]

ah ok. thank you for that info.