S300 problems

[ffichman]

S/N 20725
Software 2.3.3.0
Civic VTI B16
P28
My changes:

MSD 6AL
MSD BLASTER II HVC Coil
MSD IGNITION SC COIL DRIVER
ACCEL 300+ Thundersport

My car does not read any sensor. Sometimes the sensors appear on the screen of Hondata and then disappear. The car does not exceed 4000rpm spin.

[Spunkster]

Has jumper J12 in the ECU been cut?

[ffichman]

Yeap!

[ffichman]

Now we can see the module information only once.
The sensor values are all wrong.
The light turns red Hondata constant.

[Spunkster]

Post pictures of the soldering on the bottom of the ECU, make sure they are high quality and in focus.

[ffichman]

Photos

[Spunkster]

This s300 has not been installed correctly. You will need to talk to whoever installed this to see if they can do it properly. Unfortunately there really isn't' much else I can offer.

[ffichman]

Reinstalling the Hondata was done properly and the problems remain. What do I do?

[Hondata]

The next step would be to swap the s300 into a known good ECU.

The photos show that incorrect pins have been used on the ECU and the s300 connectors have been cut away for soldering - how was it reinstalled? To be blunt it looks damaged beyond repair already.