- 2005 Honda Civic Si (U.S.) K20a3 and 5 speed
- Version 3.3.1.0
- ECU part no. 37820-PND-A01)
- KManager version 3.3.1
- Mods are K&N 69 series SRI, and EMUSA 2.5" catback exhaust. Other than that, completely stock.
- I got the K-Pro from K-Tuned about a week ago with a used ECU
- a specific description of the problem:
I was putting in calibrations on my k-pro that I just got, and it is running horrible. I have an EP3 Si with a K20a3 & 5 speed, and the ECU is from a base model RSX (I am in North America). The A/F will jump up to around 32:1 even with the protection on, and work its way back down to normal again... Then after that, it will start knocking really bad. I have tried 2 different kals, and they are doing the exact same thing. I tried 89 octane tuned, and a factory kal. There is 87 octane in the tank. I am not getting any error codes or anything, but for now I have the K-Pro'd ECU out of the car until I can figure out a solution.
Car jerking at full throttle and knocking later on
Car jerking at full throttle and knocking later on
You do not have the required permissions to view the files attached to this post.
Re: Car jerking at full throttle and knocking later on
Have you contacted K-Tuned about your calibration or getting a base calibration that may work better with your setup?
Re: Car jerking at full throttle and knocking later on
No not yet. I am going to try to clean out that thing that controls the idle under the throttle body. A good friend of mine told to try that and see if it works because he had a similar issue. If cleaning it, and/or replacing that piece doesn't work, then I'll contact k-tuned about the kal if that fails.
Spunkster wrote:Have you contacted K-Tuned about your calibration or getting a base calibration that may work better with your setup?