Boost Low/High table

[DV8]

Hi guys,

trying to set up the boost by gear low/high tables. Have a switch wired up to the A/C which works fine.

Low boost table works fine - no issues. But with the high boost table i get a weird cut out no matter what i set it too.

Tested and tuned right up to 70% duty & at 70% fixed duty i don't get any cuts/stutters.

When 70% set in high table i get a weird cut issue.

Any insight appreciated. Log and map attached.

Thanks

[DV8]

I just wanted to add - in the log the AC switch is activated to high at 3:18. The 'cut/jump' can be seen at 3:24.

[DV8]

I just noticed that the switch also activates the secondary table. Hopefully all solved now.

[AREA876]

Look back at your tables because column 14 needs to be tuned

[DV8]

Look back at your tables because column 14 needs to be tuned

On the Secondary table? I don't use that table at all and have disabled it.