Kpro boost control problem

[xidmxi]

I hooked up a Mac solenoid to kpro but it doesnt work.Its powered all the time when on II and disabling it from kpro doesnt make a diffrence it stays on.I heard both Wires going to the solenoid should have +12v and the ecu from pin b21 should ground to activate the solenoid but I tested pin B21 and its grounded all the time it never has the 12v. What could be the problem?

[05typeR]

viewtopic.php?f=12&t=16778

[Hondata]

We're making a release in the next few days to fix this.

[xidmxi]

Thanks!!!

[turbosi05]

I am having the same problem even with the new release. The solenoid pulses a few times when the ignition is turned on. Then stays on continuously afterwards.

[Spunkster]

Have you uploaded your calibration using the new version of software?

[turbosi05]

Yes

[Spunkster]

From Help, about, what version of software are you using?

[turbosi05]

3.3.0.0

[Spunkster]

Please post your calibration, as I cannot reproduce a problem here.

[Nineteendc5]

I am having the same issue with the new 3.3.0
Tried it on 2 seperate laptops with 3.3.0, but i tried uploading the map on a laptop with 3.2.4 and it works perfectly. I need a fix asap!

[maxime bougie]

same problems with the new version

[Hondata]

The original problem was fixed some time ago. Make sure you have the latest software version, then follow the posting guidelines if you still have a problem.