Honda B18C1 with LM-1 Wideband Lambda Conversion Table

7rrivera7 · Post by **7rrivera7** » Tue Apr 05, 2005 4:28 pm

Is there anyone tuning Honda B-series engines with the Innovate LM-1 Wideband? If you have nailed the conversion tables for the LM-1 and ROM Editor, please let me know the values you are using for the LM-1 output and the ROM Editor table because I'm close but still not consistant.

Thanks!

2kblusiguy · Post by **2kblusiguy** » Thu Apr 07, 2005 9:11 am

I'm using an LM-1 and used the same conversion table used in RomEditor. I just programmed it with the same values it had in RomEditor as the preset, and then downloaded it to the LM-1 Works fine for me.

7rrivera7 · Post by **7rrivera7** » Thu Apr 07, 2005 4:35 pm

Ok, great. Which table did you use from the defaults in ROM Editor?

2kblusiguy · Post by **2kblusiguy** » Fri Apr 08, 2005 11:08 am

in RomEditor:

File > Settings > Lambda > Edit Conversion Table

Quick Select > Custom

Then just use these values to setup the output of the LM-1. output one or two.

ie. 0 =8.820 a/f
4.5 = 22.050 a/f

I also did a little math and made the second output output a 0-1 volt output to the Autometer cheapy a/f guage i have making the very middle stoich and the first green light 12.94 a/f, so i can look and tell what ratio i'm at at a glance. Just for driving around without the laptop and that bulky controller.

mark