S300 V2 Digital input

[crixzc]

Thank You

[RyanR]

I'm running into the same problem with an LC-2 hooked up to the serial in. I'm running the serial out on the LC-2 to I- digital in on the s300 v3 and it's reading roughly half of what the gauge attached to the LC-2 displays. I tried hooking up the ground from the serial out and there was no change.

[rondoval]

Same here, as already mentioned last year on this forum...
LC-1 hooked up to S300 V2 (SManager v2.3.3). Readings from the digital input are half of what is shown by LogWorks or logged on analog input (i.e. AFR=14 gives a reading of 7 on the digital in).

[crixzc]

Hondata? How did your testing go?

[crixzc]

We can test it again, but we have not made any alterations in that area and I would expect it to work. It will take us a few weeks to be able to test this.

:)

[Hondata]

We've made some changes to the LC1 digital input which should fix this. We think the LC1 digital steam was getting out of sync. It doesn't have a checksum for the digital packet, you you can't tell if the data is valid or not.

[RyanR]

So will these changes be implemented in the next version of sManager?

[Hondata]

Yes. However, we don't have a release planned for a while.