Data Logging problem

[aria]

-S300 V2 serial number 20894
-ECU P28
-Honda Civic 3 doors 1992 D16Z6 NA
-Std air filter, Skunk2 intake manifold, Skunk2 TB ,Hondata intake man gasket,Standard Injectors (240cc), AEM Uego wideband O2

Software SManager 2.2.7
When i was doing data logging, after the table switched to 2nd table (high speed fuel table) or when i reached VTEC point, there's no afr's data on table cells , only highlight on cell. But in first table (low speed fuel table) it could log the afr's data. Re-boot the laptop didnt work as well. I've downloaded the new updated software 2.3.0 but the problem still there.

Regards

[Spunkster]

Under Options, settings, sensor overlay, what settings to you have. It appeasrs to be working normally with the datalog and calibration you have sent.

[aria]

when switch to high speed fuel table it goes blank, no afr can be recorded, can you see it at my datalog that i posted.

thanks for reply spunkster

[Spunkster]

Change your max throttle to 120%

[aria]

Solved, thank you so much Spunkster.