K-Pro S2000, switch for start datalog...

[dduaime]

Hello, I received my K-Pro today and I look at how to setup it on my S2000 2001.

I would like to using a manual switch for start and stop my datalogging but I do not understand how.

In K-Pro software, it gives pin to connect a switch but are those of a RSX ecu.

Someone could help me by giving the equivalent of a s2000 ecu. I do not want to break something...


Thanks

[Hondata]

The S2000 pins are listed in the help file.

http://www.hondata.com/help/kmanager/ecuconnectors.htm

eg E16 PSP (RSX) = A26 (S2000)

[dduaime]

Ok, Thanks.

If I connect the switch for start and stop datalog on PSP, I have to cut the wire that goes into ecu A26.

Wire on pin A26:
Switch open = datalogging on
Switch to ground = datalogging off

And the ecu will not have the PSP signal, its will not disturb?

[dduaime]

nobody can answer?

[Hondata]

Usually it is best to remove the pin from the ECU plug (and insulate it). That way you can always return it to stock without cutting / joining wires.

Then A26 should be wired to ground via a switch.