help wiring aem 150psi sensors to s300 V2

[94turboeg]

I cant figure out how to wiring up the two sensor correctly to s300 V2 analog inputs so they will work. I tried wiring it up the same way as the autometer sensor it isn't working I need some insight.

[Spunkster]

Please provide part numbers and a link to the manual for these sensors.

[94turboeg]

Please provide part numbers and a link to the manual for these sensors.

http://www.aemelectronics.com/150-psig- ... or-kit-650

AEM Part Number 30-2130-150

[Spunkster]

How exactly do you have them wired? Where are you getting your 5v power from?

[94turboeg]

How exactly do you have them wired? Where are you getting your 5v power from?

I tried to hook it up like the autometer psi sensor D19 for 5v and B2 for the ground with NO SUCCESS.

[94turboeg]

Any ideas ?

[Spunkster]

Try a signal ground instead, D21 or D22.

[94turboeg]

Try a signal ground instead, D21 or D22.

Where should I get the 5v from?

[Spunkster]

The same place you were before.

[94turboeg]

The same place you were before.

Well I try it again, but with both sensors connected my fuel pump circuit wouldn't work

[Spunkster]

It sounds like you don't have it wired correctly then.