How do i revert a hondata ECU to run as stock?

sung · Post by **sung** » Sun Aug 17, 2003 2:01 pm

I purchased a ECU that was already chipped/socketed for hondata but i need to use it without the hondata settings for a little while... what do i have to do to make it run like a stock ECU?

Post by **Spunkster** » Mon Aug 18, 2003 10:48 am

cut jumper J1

Phat4Door · Post by **Phat4Door** » Sat Mar 05, 2005 1:18 am

So if I send my GSR ecu off to hondata and get it chipped and then get it back and put a toggle switch on j1 I can put it in my car and run it until I can get a base tune and then flip the switch back and forth between stock and the hondata? Is this correct, because if so I will send my ecu off monday.....

Phat4Door · Post by **Phat4Door** » Mon Mar 07, 2005 8:59 am

Anyone? I can't find an answer to this one anywhere hoping someone on here can help me....

Post by **Hondata** » Mon Mar 07, 2005 9:11 am

Yes you can, but why?

Phat4Door · Post by **Phat4Door** » Mon Mar 07, 2005 8:42 pm

Basically so when I get my ECU back from being chipped I can still run the GSR program until I have the time and money....mostly the money to pay to get it on the dyno that is 1 and a half hours away to get the base tune, once I get the base tune I don't need the switch, but basically I was wondering that so I didn't have to go out and get another GSR ecu to run my car until I got the base tune....Thanks

How do i revert a hondata ECU to run as stock?

How do i revert a hondata ECU to run as stock?

Toggle switch?