Hondata seems to cut power Datalog attached

[PR8urvtec]

Went around town today datalogging and notice that everything goes dead on my laptop when I started to get on the throttle in my car. If you look at the datalog you will see flat lines on the graph when I get on the gas. The engine rain fine and my fuel was looking good in boost according to my a/f gauge. Power felt consistent during every pull in third gear. I've never seen this happen before. Any suggestions?

[Hondata]

Try disabling the on-board datalogging.

[PR8urvtec]

Try disabling the on-board datalogging.

Ok. I'll give that a go. Thanks. I'll update the thread when I try it out.

[PR8urvtec]

Just took the car out and after disabling on-board datalogging everything seemed to work fine. Thanks for the help.

Ryan