Kpro wont connect to laptop

[2.4_turbo]

I have a 2004 Civic with a 2004 a2 swap, i am just completing the swap and i purchased a used kpro'd ecu from a local car forum. I was aware of the potential chance i would take buying used but i made him plug the ecu into another swap car so i could see it work. Since it seemed to work perfect i took it. I put it in my car and it fired up but didnt run great, i assume thats due to the tune he had since it was for a big injector cammed motor, so i tried to connect it to my computer to put a tune in.

This is where the problem begins, my computer(s) wont download the proper drivers and dont even recognize the kpro. It just says ''USB<-->Serial'' in the device manager. I have been searching google and this forum for 2 weeks and have tried 100s of different methods, none of which worked yet.

Any help would be great!

[Hondata]

See http://www.hondata.com/forum/viewtopic.php?f=12&t=3629

[2.4_turbo]

Oh sorry..

- 2004 Honda Civic SE
- K-Pro # 05007886
- ECU part # 37820-PRB-A06 and serial# 2068-603753 0A22
- KManager version 3.2.4
- Dont know the calibration yet
- Unable to Datalog anything yet
- Motor is a pretty much stock K20A2 with a CAI and Header
- Purchased K-pro'd ECU used
- a specific description of the problem is located in first post

Thanks!

[Spunkster]

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions (include a link to this thread):

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

[2.4_turbo]

Thank you!