Log+Map Help (02 RSX-S I/H/E/RBC)

[Mekks]

This map is the jhonny6edit from keto06 with a few small changes.

02 RSX-S (USDM K20A2)
HKS High Power Exhaust (turbo model)
RBC Manifold + Hondata Gasket
Injen CAI
CRSX/KIDD Race Header

I logged in open loop, 3rd gear pull at start of map and around 15 min of highway/around town driving for the rest of the log. The cam/fuel has not been changed from the default map settings when I downloaded it.

Any help would be great, In closed loop I tend to get a few knocks while going up hills and in the low rpms (throttle slightly open). BUT I could not get it to knock while logging. I'm guessing the map is running rich due to my MPG but what would I know.

Log/Map are in a ZIP file, was too large to attach to the forum

https://dl.dropboxusercontent.com/u/259073/log-map.zip

[Mekks]

nobody =(

closest tuner is about 5 hours away and wants $600+ for tune/dyno time.

[LK7R]

Fueling is a mess. Running way too rich for N/A setup (should be around 13). You are running around 11.5 at WOT most of the time (that is just abour right for FI) and even richer after VTEC crossover.

Tried to fix it a bit, test it out and do some datalogs (3rd gear pull - 3-4 times and some cruising).

It might be better to start from base map "K20a-itr.cal" from which seems to be this cal originating anyway.

[keto06]

That johnnykal seems to show up everywhere.

[Mekks]

That johnnykal seems to show up everywhere.

^^ just sent you another log, thanks again for the help!

[morfin06]

I have a 2003 type s with i/h/e and the rbc mani would this map work. I.just want it to run decent until i go tune.just got the kpro so im not sure what would be best. Any advice?

[keto06]

There is a good map floating around here somewhere. Look through my old posts.