need b16a turbo base map

[abdullahjamo]

just got my new engine and s300v2 in and looking for a basemap to get me started I have ....


car type civic 1995 4 door
b16a
2 1/2 inch exhaust system
garrett nissan rb25 turbo open at 1 bar
OMNI 3 bar B series map sensor
AEM fuel rail and regilator set at 43 psi
1000cc precision injectors
Skunk2 66mm Alpha Throttle Body
BLOX POWER INTAKE MANIFOLD up to 72mm
Golden Eagle Cam Gear Gears
Wiseco Forged Pistons Eagle Rods 10.75:1 81mm
b18c type R camshafts and lifters
ARP main and head studs
AEM UEGO Wideband O2 Air/Fuel Ratio Gauge and the Bosch 4.2LSU sensor
cometic std size and bore head gasket
ACL Race BEARINGS Kit
Vtec Gates Racing Belt Timing Kit
5 bar fuel pump

[Progress]

Are you sure you got omni 3 bar map sensor.

[abdullahjamo]

Are you sure you got omni 3 bar map sensor.

yes its the 3 bar one. it says 3 bar on it and when I put in the scalar and offset from the omnipower support page for the 3 bar one it worked.

[abdullahjamo]

Any help?

[Progress]

I have 1000 cc map but its a 4 bar sensor

[abdullahjamo]

I have 1000 cc map but its a 4 bar sensor

could you send me it plz. I can fix the map sensor settings