manual to automatic

never2low · Post by **never2low** » Mon Feb 07, 2005 5:07 pm

My 1994 Integra LS is an automatic. I am converting to a GSR manual transmission and i am tring to figure out if there are any wires that a will have to change or sensor i will have to bypass to do so, and i am trying to find out if if the computer for the GSR will work.

Post by **Spunkster** » Mon Feb 07, 2005 5:21 pm

Are you changing the engine?

never2low · Post by **never2low** » Tue Feb 08, 2005 5:56 pm

yea, i'm swaping in a CRV-TECH that i built with a T3 turbo.

RMS · Post by **RMS** » Sun Feb 20, 2005 10:23 pm

you will have to wire in the clutch interlock and the reverse lights. nothing else that effects the ecu is a problem.

never2low · Post by **never2low** » Mon Feb 21, 2005 8:20 pm

for the clutch interlock and reverse lights, am i just going to bypass sensors with a wire changing the wiring in the harness?

RMS · Post by **RMS** » Mon Feb 21, 2005 9:51 pm

from the shifter plug you will have to run two wires over to the clutch switch. from the shifter plug you will also have to run two wires to the transmission's reverse switch...i think that is all.