repacement MAP sensor always 2kPa

[sashg]

Hi Hondata,
I have a trouble with MAP sensor.
I was checked 3 different map sensos ( stock,AEM,denso).
Then i checked "stock MAP sensor" with connected stock sensor - always works fine. engine works without any problem. Voltage is correct for stock sensor and for another sensors.
But then I checked "Replacment MAP sensor" and upload calibration - I see only 2kPa pressure with any type of sensors any settings of Scallar and offset.
PLS need advice!
K-Pro v3 Serial number 10013.
Thanks

[sashg]

the problem was solved!
Then we are using stock map scheme - hondata update maps sensor always.
Then we are using Replacement Map sensor scheme - map sernsor voltage updates then engine is canking or runining.
BR!
Sash