B16A2 with 81.5 type R pistons - MAP HELP

[R G Marendaz]

Hi everybody,

Could someone help me with my map?

B16a2

- AEM CAI
- NIPPON 81.5 TYPE R pistons
- MSD KIT
- WALBRO FUEL PUMP
- AEM WIDE BAND
- IRIDIUM SPARKS

I also have, s2 pro2 cams, s2 valve springs, supertech titanium valve retainers, buddy club high compression head gasket, AEM fuel rail and pressure regulator, 500CC fuel injectors... but I didn't put all of these yet. Actually I'm little afraid with this cams.

Currently I'm using gas but I can use Ethanol as well.

What do you guys suggest me?

Tks in advance

[Progress]

B16 crank and b16 rods with type r 11.1:1 pistons right. Whats the gasket thikness

[R G Marendaz]

I think is the same like the original.

[Progress]

You should be around 10.6:1 with this setup. Use a jdm B16 base map. 50 psi of fuel pressure with factory injectors. It should run and get it to a tuner. then swap the injectors and tune it.

[R G Marendaz]

I recorded the datalog with stock injectors. Find enclosed, watch and than let me know what you think about it.

Tks

[Progress]

you need to fix your speed sensor. and you running lean at wot. part throttle looks ok.