Need Map for h22a4 boosted UPdate 5/27

sIx · Post by **sIx** » Mon May 27, 2013 2:12 pm

Ok.....clearing some things up. again, I WENT OFF from what the guy I bought the car from told me as for what parts it has and whats all done to it. Just found out, that the injectors are NOT 750cc as he stated....but 440cc, checked the serial number " Delphi 42lb (01D030B) injectors " yesterday....I went on ahead and tested launch control settings on smanager to see if it worked, and set launch control 3500 just to test, well it worked, before doing so, I did download the current settings ecu, just in case something went wrong.....well after changing the launch control....the car has a hard time turning over.... when it does, idles very low and if u give it gas, it revs up then just dies.....im also Hearing SHHHH sounds coming from the injectors, over and over now.... I turned off the car.....uploaded the original map to ECU from my laptop and car started up fine again and that SHHHH sound was gone....until 2 mins later after idling....I gave it gas and then it just died....been in my garage since.... kinda afraid to turn it on now.....wtf did I do?? I uploaded my Calibarations, but it says not downloadable yet......anyone know why?? I can email it to you if need be just PM me let me know if anyone cn help

sIx · Post by **sIx** » Mon May 27, 2013 3:43 pm

Just got the car started again.....wooooo!!! Thought she was a goner for a sec :) don't know what I did, but its back, and im NOT doing nothing else to it, till its tuned right using a Map for now, till 4-6 weeks then I can take it to get a Real tune.
Doing datalogging as I type ..... just letting it run and idle for a bit. If u need that too let me know..

Updated parts... The dude was wrong about some parts. which is concerning the hell out of me now, but anyhow.... it doesn't have 750 injectors....it has 440cc, Delphi 42lb (01D030B) injectors that's what I found googling the damn things....also I have a BBK 70mm throttle body as well...ok...moving on.....Damn I love the AC in this car ....Texas heat sucks!

blackrhino · Post by **blackrhino** » Mon May 27, 2013 5:05 pm

ok your map I've seen a few things.. what your seeing with the not downloaded yet just means no one has downloaded it yet to look...

What map sensor are you using??? in your tune you have stock selected... also it is scaled to 550cc injectors not 440 as you state... figure out what map sensor you have and put it up...

You NEED to get a wideband... your dataloging means nothing without it...

blackrhino · Post by **blackrhino** » Mon May 27, 2013 5:13 pm

also vtec is set super low... Datalog again this time let the car warm up all the way before datalogging... wait till the ect gets to about 180 or so before hitting the record button...

sIx · Post by **sIx** » Mon May 27, 2013 6:09 pm

from what I see, its showing 240cc for stock and 550cc for current. My Vtec is set ar 3000, DAMN! what the hell for?? Please note....I did NIOT tune this, its the way I got it.....does it need work?? Yes....and that's why I got it....to learn, and firmilarize my self with it and tune it..... its a project....so Thank you ALL for taking time and being patient with me.

as for the Map sensor....Im going to assume, its stock, If your referring to the sensor on top of the throttle body which Im assuming its it....says " Denso 079800 5v PS-30" from what I see online its a stock map 2 bar?? Not sure. no freakin idea how to locate my crank sensor and see what it is?

blackrhino · Post by **blackrhino** » Mon May 27, 2013 7:03 pm

how much boost are you running???

sIx · Post by **sIx** » Mon May 27, 2013 7:12 pm

8 lbs.... Which I want to bring down to 6 lbs nb

blackrhino · Post by **blackrhino** » Tue May 28, 2013 2:14 am

ok so that told me a lot... even though you didn't drive in that data log I noticed something and looked it up in your calibration... your base timing on a h22 is supposed to be 15... your ignition map is set at 20 degrees... wow... I know you didn't make this map. don't think im getting on you... Can you afford to get a wideband???

sIx · Post by **sIx** » Tue May 28, 2013 4:42 am

Nope.... It doesn't drive anymore after setting up launch control and then putting original map back on. Just starts and idles low. If I press the gas it dies. As for the wideband. Im looking into getting one soon.... Hopefully next few days. And not taking anything personal here..... So thanks again for takin a few mins tO help me out. Off to work I go.... But I'll check the site thru out the day

Hondata

Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27

Re: Need Map for h22a4 boosted UPdate 5/27