Tuning on an s300 v1 then moving the cal to an s300 v2

[7rrivera7]

If the version of Smanager stays the same, will a calibration created on V1 hardware work on v2 hardware without changes? I was asked this by a client waiting for his v2 board but in the need to tune his car today on v1 hardware and does not want to lose his investment in tuning/dyno time.

[Spunkster]

Yes, you will have to reupload the calibration once the new s300 arrives.

[7rrivera7]

Excellent - thank you. Just to validate, a V1 hardware tune will run exactly the same on V2 hardware.

[Spunkster]

yes