S200 problems

dnatrance · Post by **dnatrance** » Tue Dec 28, 2004 11:09 pm

Ok I have a p72 ecu that I tried putting the hondata in... I put the small chip in, socket, put the resistor with the one black bar on j1 and cut j12. The hondata chip is facing towards the harness and the engine starts in limp mode... now if I put in a skunk 2 chip, it works fine.

Now I saw in the instructions that can be if you do not have the correct chip for your ecu... when I ordered the system I just asked them to put a type r base map... they didnt ask me what ecu I was putting it in. does that matter? do they have to program it around which ecu you have?

if not what the hell is wrong with it?

Post by **Spunkster** » Wed Dec 29, 2004 10:16 am

IS the light on the interface box flashing or solid?

dnatrance · Post by **dnatrance** » Wed Dec 29, 2004 12:22 pm

flashing

dnatrance · Post by **dnatrance** » Wed Dec 29, 2004 12:24 pm

flashing

Post by **Spunkster** » Wed Dec 29, 2004 3:17 pm

It sounds like you either have no basemap or have an incorrect one. Contact your dealer for a proper basemap.

dnatrance · Post by **dnatrance** » Thu Dec 30, 2004 2:14 pm

yeah they forgot to load the basemaps...

by the way.. I need to find a p30 or p72 ecu... know where I can get one at a decent price?