I am having problems running KManager to connect to the ECU now... I Accidentally been working on my girlfriends ep3 for the last 2 months and well when I jumped on my ep3. I had a CEL... What I did was pull the 15AMP fuse from under the hood to reset the CEL... (I had forgotten that I had KPRO) Then when I realized it after I had put the fuse back and everything I ran to get the laptop. connected the USB Cable to the KPRO Ecu and well it didn't read anymore... Is there anything I can do?
KPro Ser#:2370
Vehicle is 2002 Honda Civic Si
Engine: K20A3 (ep3)
ECU: Says by the Harness connectors: 37820-PNF-A05 (971782-2Z04) And the exterior of the ECU another Label says:37820-PNF-A05 (971782-2Z06) Made in UK. The 6 & the 4 are different and also KPro came off of a 2003 Honda Civic Si (Ep3) with less then 60K Miles on it.
Intake: AEM V2 with Velocity Stack
Exhaust: Stock Header, test pipe, catback Mandrel Bent Apexi N1 Exhaust.
Any help would gladly be appreciated... I'm very lost and confused as of right now. I feel that I ruined my KPro... I can provide pictures as well.
KPro not reading anymore...
KPro not reading anymore...
You do not have the required permissions to view the files attached to this post.