S300 Upload Problem

[logan]

I was able to upload cals yesterday, but I am know getting an SManager error: "Upload failed - please try uploading again." I have checked and re-socketed the S300, but still unable to upload. Can anyone help?

[ncjmj]

If it's an S300 V2 you have to be connected to the Internet to upload new cals

[Hondata]

Not quite. You need to register the s300 (once) over the internet, but after that you do not need to be connected.

[logan]

Yes I had registered it over the internet, then with the internet connected it still could not upload.when I try to upload the ecu flashes red when I try to upload. I can download off the ecu to smanager but can't upload from smanager to the s300.

[Spunkster]

What is the serial number on the s300 board inside the ECU? From Help, About, what version of software are you using?

[logan]

20960 version 1.2.

[logan]

Version 2.1.1

[Spunkster]

No need to post here and email. This will be handled via email.