s300 and new mac computer

[muddauber351]

Hi I just got a new mac computer I got windows xp installed just fine and loaded the s300 program I went to update drivers and everything looks fine. I can open a file make changes but cannot get it online so I can load it on the ecu. I checked my cable and its good any ideas? thanks John

[Hondata]

Are the USB drivers installed (normally on XP they always install correctly)?

See http://www.hondata.com/help/smanager/us ... ooting.htm

[surfingsk8r]

Connect the device and when connected make sure that the right driver is selected to run the device. On a mac im not sure how this works but on a PC you would go to the device manager and find your new hardware device that you plugged in and click on its properties to show you the driver being used, from there you can change that.