K24/K20 Map

[its_ish]

Hi, I need a map for the below set up so that I can drive the car to the tuners.

K24 block with 12:5 CP Pistons and standard rods
K20 head with Spoon cams and OBX Valves and retainers
DC5 K20 Type R injectors
T1R Exhaust Manifold
2.5" Exhaust system
RBC manifols
Spoon 70mm throttle body

Please email me at israel@jaycar.com.au

Thanks!

[its_ish]

whats the turnaround time on map request in this forum?

[Spunkster]

http://www.hondata.com/forum/viewtopic.php?f=14&t=8776

[its_ish]

I have and read the post and am back here...
There are no K24/K20 base maps available in the KManager that is close to my requirements.
I would've thought that Hondata would have hundreds, if not thousands of calibrations
from your database of tuners from around the world that is close to my engine set up
specifications.

[05typeR]

Hi mate,

Since you only need to get by your tuner(s) I would suggest adding about 5-10% more fuel and decreasing the ign a few degrees on a map for your car/motor
.
if you have flash mil with knock enable and a AFR gauge keep looking at these.

[tomzauto]

i can def help you out, check out my site

tomzautotuning.com or email tomzauto@yahoo.com