peter.d wrote:So what exactly Hondata did to help you ?
Are you running FlashPro with TSX ECU ?
Hondata made new FlashPro manager where you can disable EVAP errors that CL9 euro dash would be clean from "check engine" light.
Core58 and I using TSX ECU 07-08 with FlashPro in our Accord CL9 euro. You must buy same kit as for TSX 04-06
hello for the accord cl9 do i need to buy this kit http://www.hondata.com/flashpro_tsx.html
and the Adapter kit for the tsx 2004-2006 then a tsx ecu 07-08?
does it work on cl9's older than 2006?
thank you
viggen wrote:hello for the accord cl9 do i need to buy this kit http://www.hondata.com/flashpro_tsx.html
and the Adapter kit for the tsx 2004-2006 then a tsx ecu 07-08?
does it work on cl9's older than 2006?
thank you
Hi, so I have flashpro ordered. I was just checking my CAN Connector, and there seems to be no slot empty in which to connect the CAN Adapter harness. There are 7 slots, like in the pdf showing how it's done, but all are full!!?? Is there any other place where I could connect the CAN Adapter, or am i out of luck?? I saw there is a green Block, right beside a Brown Block, closer to the front of the glove box, with color dotted wires, but i fear this is my audio system connections.. I drive an 07 Accord cl9 executive. Any help would be very cool!!
Thanks
Mounty
You do not have the required permissions to view the files attached to this post.
Last edited by Mounty on Wed Feb 20, 2013 2:17 am, edited 1 time in total.
So, i found out, thanks to mabo, that i will have to solder wires to the High and Low CAN connectors, either on the ecu/ecm side of the wiring harness, or up under the glove box to the CAN connector.. (Red/grey dots>CAN Low and White/grey dots>CAN High, 3rd plug from the top in the pictures) if anyone is having troubles @ ecu/ecm side. it's the right most connector, pinned as in picture below.
Mounty
You do not have the required permissions to view the files attached to this post.