PRB for 05-06 RSX

[Piv]

Hello, one of our customer bought the whole 05-06 RSX hondata kpro kit from the US

The problem is, it's for a 05-06 JDM Integra type R which run with a PRC ECU and the ground sensor coming from the VTC solenoid does go back to the stock ECU

The PRB coming from Hondata has VTC - and VTC + connected through a resistor, I was wondering if that's the only modifications Hondata does for the PRB 02-04 RSX ECU to run on the 05-06 ?

If yes, I'm guessing if I'm removing this resistor the VTC will work fine on the ITR ? (At the minute it doesn't)
Is the Kpro board untouched ?

Thank you,

Romain

[Spunkster]

No, this will not work on that vehicle. The 05-06 RSX kit is for North American vehicles only.

[Piv]

I didn't use the "kit" but just the ECU which I know is plug and play on our JDM DC5 (I'm not using the harness conversion, it actually doesnt work with it anyway as the 05-06 RSX doesnt share the same wiring as the 05-06 JDM ITR)

Everything's working except the VTC which stays at 0 on idle and goes at -2deg as soon as the ECU should send a signal

I'm guessing if I'm removing this resistor the VTC will work fine on the ITR ? (At the minute it doesn't)
Is the Kpro board untouched ?

If you rather to send me the informations by PM that's fine by me, just need to know if thats the only modification done as if yes I could go backward to use that ECU on the DC5

[Spunkster]

That ECU will not work on the vehicle you have. You will be much better off selling that to someone with an north american 05-06 RSX and then getting the propper ECU for your vehicle with is just a standard K-Pro.