Help!!

[shawnfuss]

Here is a datalog with me driving it, hopefully this will help you guys help me cause i am lost.

[Spunkster]

Post the calibration as well

[shawnfuss]

so i took my car into a car repair place, they said the ecu should be sent to you guys to check it. is this possible?

[Spunkster]

You need to try the ECU in a known working vehicle. If it works propelry then it means there is a wiring fault or sensor problem in your vehicle.

[Spunkster]

You need to try the ECU in a known working vehicle. If it works propelry then it means there is a wiring fault or sensor problem in your vehicle.

[shawnfuss]

i got a new ECU and the car runs now, will flood from running the 600cc injectors though. Now i need Kpro swapped over from the old ECU to the new one. how do i go about getting this done

[Spunkster]

Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:

Name:
Address:
Phone:
Email:
Serial#:

Include a link to this thread

[shawnfuss]

do you have any advice on what sensor could cause this problem?? i sent the ecu in to you guys and you said it was good so thats not the problem. a new starting point would be great as this is my only vehicle.

[Spunkster]

Check your wiring as something you have done is not correct. Based on our conversation it sounds like you did something to the wiring at the throttle body and I have no idea why. You may have to take this to someone more familiar with wiring and have them go over everything.