Can you run a NonVtec program on a P28?

sander · Post by **sander** » Wed Nov 03, 2004 9:57 am

The reason i ask this is that i used to have an LSvtec, and now have a b20, i was wondering if i could just disable the vtec pressure and spool and just use the low speed tables of the P28?

Thanks,

-sander

Post by **Hondata** » Wed Nov 03, 2004 3:01 pm

Yes, in the software disable the VTEC pressure and spool, and disable the use of the high speed cam table.

sander · Post by **sander** » Thu Nov 04, 2004 6:27 pm

Great thanks.

-s

Super-Tuner · Post by **Super-Tuner** » Sat Jan 01, 2005 11:25 pm

how do u disable the high speed cam table or do you just not use it and ignore it?

DaX · Post by **DaX** » Mon Jan 03, 2005 10:48 am

You can set the RPM at which the High Speed Cam Table engages at an unattainable RPM...like 11K RPMs.

Super-Tuner · Post by **Super-Tuner** » Fri Jan 07, 2005 9:49 pm

Cool, also should you check the box under the vtec tab that says non vtec? Im assuming yes. Also what do you do with the iab section just set it to like 8000 like the rev limiter or what