DATALOGGING EXPORT

[hoorah]

Hello,

I have been trying to export my datalogs from s300 (s3d files) SMANAGER, to csv files. Can't figure it out...
Looked over help section and forums, can't seem to locate anything. I enter my calibration, then load my datalog to see it with graphing section. That all works, when I attempt to export....will not allow. The CSV Files at base of screen shows nothing, yet when I select all files, my datalogs show up.

Please help.

[Spunkster]

Exporting to csv is only to look at the raw data in a spreadsheet. Why are you trying to export?

[hoorah]

Exporting for virtual dyno.

[Spunkster]

Have you opend the exported csv file in excel?

[hoorah]

I figured it out, had to upload the log. Once that was completed, had to exports and rename it to export as a CSV.

Thanks