Closed loop not working

[Spunkster]

It just adjusts the short term fuel trim to get it close to whatever you have it set to in the settings. It does not do anything electrically.

[B18glaw]

Can I adjust the settings on the short and long term fuel trim or do I need another map made up because this current map was done in the fall so it was colder

[Spunkster]

HAve you taken this to your tuner or asked them about this?

[B18glaw]

I had this problem when I first got my car tuned and it wasn't working properly. They suggest I conract hondata for answers

[B18glaw]

what if i raised the short term fuel trim settings higher?

going to be calling during the week soo i can actually talk to some one

[Spunkster]

http://www.hondata.com/forum/viewtopic.php?f=19&t=3772

[B18glaw]

why post that link?

[Spunkster]

becasue you still have not posted what it says to post

[B18glaw]

We've been over everything and pretty much on the same page...do you work for hondata? Absolute worst service I've ever experienced...don't want a bad wrap of hondata going around do you?

[Spunkster]

You have not posted the calibration or told us everything that has been done to the vehicle.

[B18glaw]

calibration

b18c with 84.5mm pistons
gt37r
1000cc dynamic injectors
skunk2 pro1 cams
hondata 4bar map sensor
68mm tb

[Spunkster]

Can you also provide new datalogs showing the problem using the new version of software.

[B18glaw]

here i have proved 4 datalogs 20sec each... 2 at cold start and 2 at operating temp, both temps i logged open and closed

[Spunkster]

What AEM wideband are you using? Have you tried a different input as suggested previously?

You appear to have some electrical issue as your battery voltage is vastly different between datalogs.

[B18glaw]

Currently aem uego is connected and battery may have been slightly low when first started.

What kind of electrical issues would affect the input signal...a ground?