injector 100% duty- and datalog wont download to ecu?

[boostedtech]

have a few questions, ive been resaerching alot on hondata since ive got it and have become pretty fimilar with it. i tuned my lsv turbo on 8 psi on the street with good results, now im on 13.5 psi and my 680cc injectors are showing a max duty on my graph, i was told the car had a 255 pump in it, so i never touched it. also i am running 50 psi fuel pressure, it is a cheaper style regulator. is it possible its malfunctioning under high boost? i was aware that these 680s should do me a little over 400 to the wheels, i dont think im there so im confused as to the duty cycle. im also running a very large top mount turbo, an agp zeta 3.2 wich flows roughly 77lbmin i believe.
on my graph im showing good 11.5 afr up to about 3rd gear 7k then it goes lean and i hit my lean cut that i have set. sorry its alot but i wanted to give as much info that i could.

next my datalogs...
now i can datalog just fine and record and watch everything on the graph just fine, but when i go to down load them to the ecu its showing that there is no space taken up on the ecu. here im just completly lost.
thanks hondata for any help!

[Spunkster]

Are you datalogging using the laptop and are you clicking the record button?

[boostedtech]

Yes and yes.

[Spunkster]

Then you need to save the datalog from the datalog menu at the top. This has nothitng to do with on-board datalogging.

[boostedtech]

Ok ill give that a shot. Thank you. Any input on the injectors?

[Spunkster]

Impossible to say without the calibration and a datalog showing the problem.

[boostedtech]

here ya go