tuning, advice needed

[Jays]

silly question but just need a conformation from those who are expert in tuning.

Save the calibration using a different filename - we will want to load the old calibration when we are finished in order to restore the cam angles.

Datalogging

· Start datalogging & recording (F9), then accelerate in first gear with a light throttle to 5000 rpm. The aim is to keep the throttle steady so that the engine load stays consistent as the rpm increases. You should be able to see the table tracing running straight down columns 3 & 4.

^taken from Flashpro help,part throttle fuel tuning

it tell me to save calibration under different name-checked
start datalogging and recording -checked
wait, what calibration should i use to datalog? the one with lock cam angel or the base map?

[portmaster]

For part throttle tuning you lock your cam angles and slowly accelerate. Then adjust your fuel accordingly. and go again