HELP!!

[poglife]

i bought a 96 civic with a b18c1 turbo somewhat recently and i hooked up my computer to maybe do some fine tuning and now my car wont even stay running. which is disappointing since i dont think i even changed anything... could you guys check out my calibration and see if there is any glaring error that would cause that? i would appreciate it enormously. since this car is supposed to be my dd.

[keto06]

stock injectors?

[poglife]

i was told 440. but the calibration says 240. i tried changing that but that didnt help.

[keto06]

try and mess with the overall fuel trim and see if that helps. its a bandaid, but it may help get your car running.

[poglife]

i just tried that and it didnt really change anything. i can keep it running if i keep punching the gas pedal so it doesnt die. but it bogs down if i try to hold it and stinks something horrible. its definitely not running anywhere near right. any other ideas?

[keto06]

Ive seen this happen before. Is the motor built or stock?

[poglife]

built. eagle rods, supertech valve springs, mahler pistons, 9.5:1 compression.

[keto06]

figured that was it... I bet it has something to do with the compression...

[keto06]

stock cam gears/cams at 0/0?

[poglife]

Stock gsr gears. Not sure about timing

[poglife]

Its looking like I accidentally wiped the calibration... it was trying to use a stock one which obviously didn't work. I just need one good enough to get to the exhaust shop and tuners. What stock map should I start with? For a built turbo b18c1

[poglife]

any help would be appreciated... just need a map good enough to get it running. i tried using the b18c5 revhard map and just tune the fuel but i didnt see any change. still wouldnt run. i really need some help im pretty lost here...

[poglife]

Well thanks for all the help. Not. Might as well delete don't need it anymore