clear security car starts, upload ANY kal car doesn't start

[leg3ndario]

I have a K20A type r in an EG. The car will start and runs perfectly fine after clearing security. If I upload ANY kal after that it will not start. It cranks and fires but won't start. As soon as I stop cranking it dies. I've tried multiple basemaps including the k20a-itr.kal. I can't imagine all of the basemaps being so far off that my car won't even start. I've uploaded Has anyone had an issue like this at all? I've been trying to find a similar issue on the forums for weeks. I've uploaded the datalog as well.

[Hondata]

It should not start at all after security is cleared, so I suspect that your ECU is running in limp mode when security is cleared. The datalog shows a fault with the MAP sensor.

[leg3ndario]

Thanks. I suspected a faulty MAP sensor. I should be getting one soon. What exactly in the datalog shows a fault with the MAP sensor?

[Hondata]

The MAP sensor is stuck at 5V.