hondata won't start on an 01 integra

[shaisy]

I install the s200 today and my car doesn't start
I mean it crank but it does not start the car
somehow my injectors aren't turning on cause my fuel guage doesn't go up
I had a skunk 2 obd2 to obd1 harness with the s200 install on it

I'm not sure what is wrong, cause I had a p28 computer before and it worked fine running boost with a vafc

It's not the harness cause I plugged in my old p28 ecu and it worked fine
I do notice that the blue box of the hondata had a steady red led when the ignition is on . What does that mean?

What is wrong here
Do I need to run a wire to turn on my injectors?

Please help
thanks

[Spunkster]

Is the check engine light on?

Are you getting fuel and spark?

[shaisy]

check engine is on
it won't turn on my fuel pump
i'm not gettin any fuel to ignite

[Spunkster]

Are you using an OBD1 ecu with a built in adapter harness? If so, look inside on the red circuit board and see if it says OBD2a or OBD2b.

[shaisy]

i'm using a skunk2 jumper harness from obd2 to obd1 harnes

[Spunkster]

Exactly what ecu are you using and do you know if that ecu was functional before you used it with the Hondata?

[shaisy]

i am using a p28 sent out from hondata
shouldn't it be plug and play when I get the hondata
or do I have to modify somthing
is there somthing I need to do or preloadthe software

what are you running
do you have hondata?
if so did you have the same problem or somthing similar

thanks again

[Spunkster]

What sized injectors are you running? Who burned your basemap? Who is your tuner?

It sounds as if you have a blank chip and the car is in limp mode becaseu of the fact that there may be no rim image on the chip you are using.

[Bryson]

<--- having the same issues.

Its definetly in limp mode. I'm kinda thinking its due to the fact that I'm using a Moates burner.

?