84.5mm b20vtec 11.5 comp. calibration needed asap!!!!

[gt35rdanny]

84.5mm b20vtec w/ rs machine 11.5 comp. itr pistons, b16 head p&p, itr cams ,edelbrock victor-x mani,70mm TB. need a calibration to drive it to my tuner thanks

[gt35rdanny]

bump

[gt35rdanny]

up

[hpmx18]

try this map out from a friends car

b20 block rs machin itr spec
stock vtec head just valve train
16trans

[hpmx18]

feedback greatly appreciated with all those downloads

[Mr.Dc2]

feedback greatly appreciated with all those downloads

couldnt even ran this map on my car, feels like the engine its mis-firing and about to stall out. but i love the other map you provided.

[hpmx18]

What's your compression

[Mr.Dc2]

What's your compression

10:1 its the compression

[hpmx18]

subtract 20% in colums 1-5 if its does even worse add 35% to colums 1-4

*** if you have a wideband on tha car you can adjust the fuel more easier

[Mr.Dc2]

[quote="hpmx18"]subtract 20% in colums 1-5 if its does even worse add 35% to colums 1-4

*** if you have a wideband on tha car you can adjust the fuel more easier[/quote

I end up adding more fuel instead, to get it working. but still don't feel safe and ended up switching to the other maps u provided , since its more stable. i completely understand a tune its necessarily but cant afford that right now. once again thanks for the help

[hpmx18]

no problem at all just get to tha dyno first priority

[premo583]

do you think this calibration will work with my setup

b20vtec 84.5mm
rs machine itr pistons
fully ported b16a head ferra valves
crower 2 cams and crower springs
edlebrock victor x w/70mm tb
plm RMF header
240cc injectors for now I have rdx410cc to install


I have been running it on the jdmb18c map from hondata but its not enough fuel