Problem with P28 S300 in D16Z5 D16ZC

Trooper! · Post by **Trooper!** » Sat Apr 16, 2011 4:38 am

Hello i am a german so my englisch is not the best. sorry.

My problem is: I socket my P28 with a S300. i install it with an coversation harness OBD1 to OBD0. The ECU communikate with the engine. i can see all details at the smanager. i use the d16supercharger12ohm.skl from Hodata.
But the engine do not start! can someone help me with my problem?

can someone give me an finisched data? for my setup: stock d16z5 dohc engine, stock injektors, garrett gt28rs, and an 3" exhaust and an 2" at cat up to the end.

Thank you all for your answers.

Post by **Spunkster** » Mon Apr 18, 2011 9:20 am

You do not have a heat sink on the voltage regulator and this will cause it to fail very quickly.

The calibration you are using is for 440cc injectors not stock.