Unable to datalog

comish71 · Post by **comish71** » Mon Apr 04, 2011 4:23 am

I have a k-pro setup ecu prb a05, # on kpro board is E199143 94V-0 (no clue what this means)

setup is k20head/k24

I am unable to datalog unless I do it manually. If I set the datalog parameters for "based on engine parameters" and upload this to the ecu, when I check the ecu, it never uploads the "based on engine parameter changes."

Hondata is version 14.1.0.

Thanks.

Post by **Spunkster** » Mon Apr 04, 2011 9:49 am

What is the serial number on the K-Pro? It is on a sticker with a bar code.

comish71 · Post by **comish71** » Mon Apr 04, 2011 7:41 pm

serial # 37820 prb a05

2068-501089 0j25

Post by **Spunkster** » Tue Apr 05, 2011 9:11 am

I need the serial number that is on the K-Pro board inside the ECU.

comish71 · Post by **comish71** » Tue Apr 05, 2011 8:12 pm

i do not have a bar code on the kpro board. there is no specific number onn the board. i have a serial # for ecu which is in an above post.

Post by **Spunkster** » Wed Apr 06, 2011 9:56 am

Post a good, in focus picture of the inside of the ECU, including the K-Pro board.

comish71 · Post by **comish71** » Wed Apr 06, 2011 2:17 pm

here are pics

comish71 · Post by **comish71** » Wed Apr 06, 2011 2:19 pm

here are pics

Post by **Spunkster** » Wed Apr 06, 2011 2:58 pm

This K-Pro does not have on-board datalogging. You can only datalog using a laptop.

The serial number has been removed, this usually indicates that it is stolen.

comish71 · Post by **comish71** » Wed Apr 06, 2011 3:17 pm

Well I can assure you it's not. As a matter of fact I've got my receipt and the shop that I bought it from is very reputable (one of your dealers). Now back to the more important matter at hand, is there an upgrade that can be done to the kpro so that I can datalog?

Post by **Spunkster** » Wed Apr 06, 2011 3:43 pm

If it had a serial number yes, but since it does not, we cannot offer any upgrades.

comish71 · Post by **comish71** » Wed Apr 06, 2011 6:47 pm

If I have the receipt and verification from your distributor/dealer that this is their unit then would I be able to upgrade the unit? Apparently there is an issue here that occurred before I obtained the unit and therefore out of my control.

Post by **Spunkster** » Thu Apr 07, 2011 9:17 am

No, I'm sorry, but we do not upgrade systems without serial numbers.