Secondary Table wont Switch

kerndog · Post by **kerndog** » Fri Apr 01, 2011 8:16 pm

My car is a 97 Civic DX Hatch, H22A, P28 ECU. details about the car and the switches that control the secondary tables are in the notes, under paramaters tab of my cal.

I cannot get the Secondary Tables to activate, I have tried "always on" and nothing happens. I have tried with different switches both regular and inverted in the parameters. I have tried "tables follow secondary" checked and un-checked. No matter the way I try, I cannot get the Sec Table (at bottom of sensors tab) to light up indicating I am on secondary tables. I can confirm there is no change in AFR if I remove 50% fuel from the secondary table and hit the switch or leave always on.

I want to run pump gas on one table and E85 on the other table, this working properly is an important part of having the freedom to fill up on either and just flip a switch for the right tune and more boost on the corn juice.

locash · Post by **locash** » Sun Apr 03, 2011 10:28 pm

Strange.. For the hell of it, try setting the tps activation to 1% and tapping the throttle to see what happens.

Post by **Spunkster** » Mon Apr 04, 2011 10:47 am

Don't ever use 0 as a minimum for engine speed or engine load, the computer does not like to see zeros for these values.

kerndog · Post by **kerndog** » Mon Apr 04, 2011 3:50 pm

I upped the kpa to 10 and the mininum RPM to 100 and it works perfect thanks Spunkster!

I also tried locash's recommendation and nothing changed. I didnt try the load or RPM seperate though.

Thanks for the support!