How do you disable the seconday o2 in FP

Swiftoy · Post by **Swiftoy** » Wed Feb 23, 2011 5:14 pm

I am a noob and after uploading a calibration in my s2000 I could not figure out how to disable the sensor. I could use some help

Thanks

Swiftoy

Post by **Spunkster** » Wed Feb 23, 2011 5:32 pm

It's under closed loop in the calibration window.

Swiftoy · Post by **Swiftoy** » Wed Feb 23, 2011 5:51 pm

So do I just uncheck the box with flashpro plugged into the car and computer and thats it? Do I need to reflash the toda program again?

And thank you for your help

Swiftoy

Post by **Spunkster** » Wed Feb 23, 2011 5:52 pm

Any time you make changes, you must upload the calibration to the ECU.

Swiftoy · Post by **Swiftoy** » Wed Feb 23, 2011 5:59 pm

So let me be clear on this do I go into the calibration window disable it then reflash the toda calibration again I'm a bit confused can you elaborate a little more. I dont want to screw something up.

Thank you

nunoctr · Post by **nunoctr** » Fri Feb 25, 2011 3:37 am

1- uncheck the box
2- save the cal
3- upload
4- Good to go.