replaced thermostat and now car wont rev past 5k!!!WTHcalib?
replaced thermostat and now car wont rev past 5k!!!WTHcalib?
this is the best ive got for now calibration wise, any improvements on it are welcomed, keep in mind its a stock 9:1 2.2l sohc vtec. im losing power somewhere.
You do not have the required permissions to view the files attached to this post.
no wideband, and am not dynoing, just a stock beater engine till my f20b gets back from the machine shop. and the ecu thats for the beater is hard to find for 5spd so im using what i have. just need the basics for it, and the itrstockeverything calibration wont work, so i started out with one i found for a f22, which is one ratio off so im tryin to run it a bit richer to keep from detonation. i really appreciate everyone whos here tryin to help me thanks alot. and ive found myself forgetting to untick the closed loop option, does it really make a diff or ? dont mean to sound dumb.
so was wondering bout the plx wideband, am i able to just get the 02 sensor itself and not have to worrry about the module will the s3oo just read it and act like the module?. i would google it but i have a stupid trojan that redirects me every time i try a search engine.AREA876 wrote:Do you have a wideband?
When tuning you should untick close loop operation.
so was wondering bout the plx wideband, am i able to just get the 02 sensor itself and not have to worrry about the module will the s3oo just read it and act like the module?. i would google it but i have a stupid trojan that redirects me every time i try a search engine.[/quote]danyo655 wrote:
You need both the wideband sensor and the module for it to work.
Finally
the tdc sensor inside the distributor was cracked found out after it completely died on me today. so i had another distributor layin around from an obd1 accord nonvtec which had the same pickups in it so i depinned a few wires here and there and repinned them into the new plug and reset the timing and the distributor and now i got 99%power back, still gotta fine tune the timing manually. will post the updated calibration sometime tomorrow. i gotta go get my f20b back from the machine shop and take it to another seeing as they did nothing i asked them to do over a period of 2 months, and then had the audacity to charge me for storage when it was them who took to long to do anything. plus i hear bad things about them from about 5 diff people so it scared me. but once again thanks to all who helped.