Ok, I have a problem with my K-Pro. I installed everything, and went to dump a program into the ECU, the only problem is that the K-Pro manager isn't reading an ignition signal to the ECU, thus I can not download any calibrations. I checked the red and green lights, and while the ECU is plugged into the laptop the green light is on, and the red is flashing, but even with the ignition on, the status led's don't change. I have checked the black/yellow stripe wire at the ECU for the ignition, and it is reading correctly, ( I checked with a fluke mulitmeter, and it was reading over 12 volts with ignition on, and 0 with the ignition off) So any clue to what might be the issue? Any help would be greatly appreciated.
Thanks
Eric
