Nitrous control?

Vtec6000 · Post by **Vtec6000** » Wed Jan 12, 2011 3:48 am

Can someone tell me which model ecu has the needed hardware to be able to control Nitrous as I have been told not all kpro installed ecu's has the needed hardware to switch a output.

Post by **Spunkster** » Wed Jan 12, 2011 10:15 am

http://www.hondata.com/ecus.html

Vtec6000 · Post by **Vtec6000** » Wed Jan 12, 2011 4:04 pm

Thanks Spunkster. Do you if the needed hardware can be added to a PRC ecu?

Post by **Spunkster** » Wed Jan 12, 2011 4:42 pm

No it cannot.

Vtec6000 · Post by **Vtec6000** » Thu Jan 13, 2011 9:12 am

Spunkster wrote:No it cannot.

Not what I wanted to hear aha :D

Will the arming input work on a PRC ecu? i.e If I was to wire a trigger signal to one of the selectable inputs would the fuel and ignition correction work? and I could just have a manual switch to start the nitrous spraying.

Post by **Spunkster** » Thu Jan 13, 2011 10:52 am

The FANC output can be used as it is not part of emissions controls. Have you tried that?

Vtec6000 · Post by **Vtec6000** » Thu Jan 13, 2011 5:06 pm

Spunkster wrote:The FANC output can be used as it is not part of emissions controls. Have you tried that?

Interesting, so I could use B6 FANC output to trigger my Nos relay? I assumed non of the outputs would work with the PRC ecu but if that will work then great 8)