Kpro doesnt upload

sebs · Post by **sebs** » Sat Oct 23, 2010 3:33 am

Hey, i tried uploading a changed configuration to my kpro but after upload, and redownloading it it doesnt show as changed. I sometimes get a memory access violation error, and the datalogging doesnt seem to work either.

Is this a problem with me using windows 7 or am i doing something wrong?

sebs · Post by **sebs** » Sun Oct 24, 2010 9:41 am

It's a PRA ecu, when i try to upload any changes like a simple checkmark setting, or the injector size, it says uploading with the bar for around 1 sec, then when i download to verify it'll be unchanged.

Also i lose the connection to the kpro after uploading usually.

I've updated and ran the "check usb drivers"

Post by **Spunkster** » Mon Oct 25, 2010 9:44 am

Downloading is not recommended, especially to check parameters. Close the program, reopen it and then load your calibration, make your changes, save the file and upload it to the ECU.